Arecont Vision H.264 Day/Night SurroundVideo
®
Series Installation Manual
7 | Page
Adjusting Each Sensor Tilt : ( AV8365DN only)
NOTE: Each sensor tilt angle can be adjusted
by +/- 10° to remove the dead spot at dome
bottom or at the horizon.
15. To adjust each sensor tilt angle, use a #1
Philips screwdriver to turn set screws, shown
in Image 19 and Image 20.
16. Remove the protective film from the camera
dome.
NOTE: be careful not to scratch the vandal
dome cover.
17. Secure the vandal dome cover to the camera.
NOTE 1: Day/Night switcher per sensor in
both AV8185DN and AV8365DN shown in
Image 19.
NOTE 2: All Day/Night switchers
simultaneous switchover, based on the least
(or greatest) illuminated sensor.
Image 19
Image 20
Comments to this Manuals